ARRI ARRIFLEX 235 - Manual (Page 64)

64 64
Switching On and Off the Warning Signal for
Asynchronous Running (Mode 4)
Standby Operation
• Change from Mode 1 to Mode 4 by depressing the
“MODE”-button three times.
• By depressing the “SEL”-button once, activate the
display for setting the warning signal.
• Within three seconds, depress the “SET”-button to
select one of the four settings.
• Depressing the “MODE”-button confirms the selection.
Display Warning tone on start Warning tone on stop
LS
_ _ off off
LS – _ on off
LS _ – off on
LS – – on on
Setting the Volume of the Warning Signal
• Change from Mode 1 to Mode 4 by depressing the
“MODE”-button three times.
• Depress the “SEL”-button two times to activate the
display for setting the warning signal volume.
• Select the desired volume with the “SET”-button.
0…off
3…maximum volume
Camera Operation