IDEC High Performance Series - Manual (Page 1398)

6 HG2S
34-82 WindO/I-NV2 User’s Manual
6.8 Installation
●
Operating Environment
For designed performance and safety of the HG2S, do not install the HG2S in the following environments:
• Where dust, briny air, or iron particles exist.
• Where oil or chemical splashes for a long time.
• Where oil mist is filled.
• Where direct sunlight falls on the HG2S.
• Where strong ultraviolet rays fall on the HG2S.
• Where corrosive or combustible gasses exist.
• Where the HG2S is subjected to shocks or vibrations.
• Where condensation occurs due to rapid temperature change.
• Where high-voltage or arc-generating equipment (electromagnetic contactors or circuit protectors) exists in the
vicinity.
●
Ambient Temperature
• Install the HG2S in such a way that it will not be exposed to heat generated by other equipment.
• If there is no need to operate the HG2S, mount it onto a wall or a stand. Use the attached mounting bracket for
wall mounting.
• Do not apply force to the D-sub connector directly.
●
Installation
Use the attached mounting bracket and follow the procedure given below to mount the HG2S onto a wall.
• Install the mounting bracket (HG9Z-PK2) to the HG2S as shown in the figure below.
• Drive in two screws on a wall to hang the HG2S.
• Hang the HG2S on the screws as shown below.
• When installing the attached mounting bracket, tighten the four screws to a torque of 0.4 to 0.5 N-m uniformly.
Excessive tightening of the screws will deform and damage the HG2S.
• Mounting Bracket (HG9Z-PK2) [Unit: mm]
CAUTION
Do not tighten excessively, otherwise the HG2S may warp and cause wrinkle on the display, or
impair the waterproof characteristics.