IDEC High Performance Series - Manual (Page 538)

2 Character Input
10-26 WindO/I-NV2 User’s Manual
2.3 Properties of Character Input Dialog Box
This section describes items and buttons on the properties dialog box.
●
General Tab
■ Part Name
Enter a name for the part. The maximum number is 20 characters.
■ Keypad
Configures the keypad for entering text in the Character Input.
*1 Advanced mode only
Use as Display for Keypad *1 :
Select this check box to only use the Character Input as a part to display the
text entered with the keypad.
Type: According to the location where the keypad is configured, selects the type from the following.
Standard:
Uses the standard keypad. The standard keypad is the keypad configured as the
popup screen for the standard keypad (screen number 3000 to 3015).
Popup: Uses a keypad configured as a popup screen.
Current Screen: Uses the keypad configured on the same screen as the Character Input.
Screen No.: Specifies the screen number of the popup screen configured as the keypad (1 to 3015).
This option can only be configured if Popup is selected for Type.
Adjust location automatically: Select this check box to display the popup screen configured as the keypad in a
location where it will not overlap the Character Input.
This option can only be configured if Standard or Popup is selected for Type.
Coordinates X, Y: Specifies the display location of the popup screen configured as the keypad.
With the upper-left corner of the screen as the origin, the X and Y coordinates are the upper-left
corner of the popup screen.
This option can only be configured when Popup is selected for Type and the Adjust location
automatically check box is cleared.
HG2G-S/-5S/-5F, HG3G/4G, HG1F: Specify the coordinates in 1 dot units.
X: 0 to (base screen horizontal size - 1)
Y: 0 to (base screen vertical size - 1)
HG2F/2S/3F/4F: Specify the coordinates in 20 dot units.
X: 0 to (base screen horizontal size - 20)
Y: 0 to (base screen vertical size - 20)