1 counting operation time and operation count, Counting operation time and operation count -4 – IDEC High Performance Series User Manual
Page 912
2 Preventive Maintenance Function Configuration Procedure
17-4
WindO/I-NV2 User’s Manual
This section describes the configuration procedure for the Preventive Maintenance function.
2.1 Counting Operation Time and Operation Count
1
On the Configuration tab, in the System Setup group, click Preventive Maintenance.
The Preventive Maintenance Settings dialog box is displayed.
2
Specify the number of devices to monitor in Number of Items.
3
Select the item to display in Settings with Display Options.
Select Operation Time + Operation Count.
The Operation Time and Operation Count settings are displayed in Settings.
4
Select the number to register the Preventive Maintenance settings to in Settings, then click Edit.
The Individual Settings dialog box is displayed.
5
Specify the bit device or bit of the word device to monitor with Monitor Device.
Click
to display the Device Address Settings dialog box. For the device address configuration procedure, refer
to Chapter 2 “5.1 Device Address Settings” on page 2-67.
2
Preventive Maintenance Function Configuration Procedure
HG3G
HG2G-5F
HG2G-5S
HG2G-S
HG4G HG1F HG2F HG2S HG3F HG4F