NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 413)

11. From the Routing Mode menu, select Enable or Disable to enable or disable the
routing mode for the interface.
The default is Disable.
12. From the Admin Mode list, select Enable or Disable to enable or disable the
administrative mode of the interface.
The default is Enable.
13. In the MTU field, specify the maximum transmit unit for the interface.
The range is from 1280 to 1500. The default is 1500. If you enter is 0, you disable
routing on the interface.
14. In the Duplicate Address Detection Transmits field, specify the number of duplicate
address detection (DAD) transmits for the interface.
The DAD transmits value must be in the range from 0 to 600. The default is 1.
15. In the Life Time Interval field, specify the lifetime interval that the interface transmits
in router advertisements.
This is the information about the period during which IPv6 neighbors can use the
interface as a default router.
The range is from 0 to 9000. The default is 1800. The value must be greater than or
equal to the maximum advertisement interval. If you enter 0, the interface cannot
be used as the default routing interface.
16. In the Adv NS Interval field, specify the retransmission interval information that the
interface transmits in router advertisements.
This is the information about the interval between neighbor solicitation
retransmissions.
The range is from 1000 to 4294967295. The default is 0.
17. In the Adv Reachable Interval field, specify the reachable interval information that
the interface transmits in router advertisements.
This is the information about the period during which a remote IPv6 device is
considered reachable after receipt of a neighbor discovery confirmation message.
The range is from 0 to 3600000. The default is 0.
18. In the Adv Interval field, specify the period between router advertisements from
the interface.
The range is from 4 to 1800. The default is 600.
19. From the Adv Management Config Flag menu, select Enable or Disable to enable
or disable the router advertisement “managed address configuration flag” for the
interface.
When enabled, end nodes use DHCPV6. When disabled, end nodes automatically
configure addresses. The default is Disable.
Main User Manual 413 Manage Routing
Fully Managed Switches M4350 Series Main User Manual