NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 786)

The System Information page displays.
5. Select Security > Control > Captive Portal > CP Trap Flags.
The CP Trap Flags page displays.
6. Configure the following trap flag settings:
• CP Trap Mode: Enable or disable the captive portal trap mode.
• Client Authentication Failure: Enable or disable the transmission of a trap if a
client fails to authenticate with a captive portal.
• Client Connect: Enable or disable the transmission of a trap if a client
authenticates with, and connects to, a captive portal.
• Client Database Full: Enable or disable the transmission of a trap each time an
entry cannot be added to the client database because it is full.
• Client Disconnect: Enable or disable the transmission of a trap if a client
disconnects from a captive portal.
By default, these trap flag settings are disabled.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
Display or clear captive portal client statistics
You can display or clear captive portal client statistics, including statistics about traffic
sent and received by individual clients.
To display or clear the captive portal client statistics:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
Main User Manual 786 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual