Leprecon LP-1600 Series - Manual (Page 13)

13
To clear ALL memory in the LP1600, start by pressing the Setup menu button.
Turn the data wheel to the right, until the following message is seen:
Erase Everything
? (MOD = YES)
To proceed with the erase, press the Modify button. If you get cold feet, press
any other button, such as the Run button. Assuming that you really do want to
clear all memory, and you have pressed the Modify button, one last warning
will be issued.
LOSE ALL DATA
? (REC = YES)
Pressing the Record button at this prompt will definitely clear all the
information in the console. Once this has been done, the data is gone for good.
The LP1600 will verify this:
All Data
Memory Erased
In the case of erasing ONLY presets, or ONLY chases, use the appropriate
screen in the Setup menu. The procedure of pressing Modify, then pressing
Record, is the same regardless of the data being erased. The Preset Erase
screen looks like this:
Erase All Scenes
? (MOD = Yes)
The erase screen for the programmable chases reads as follows:
Erase Chase 5-11
? (MOD = Yes)
The erase screen for the programmable chases reads as follows:
Erase All Cues
? (MOD = Yes)