Leprecon LP-1600 Series - Manual (Page 57)

57
5 05 STACK SELECT pressed
6 06 STACK ON pressed
7 07 YMODE CHAN pressed
8 08 YMODE PRES pressed
(9 09 STACK GO pressed(*** removed in v3.02 ***)
10 0A BANK SELECT HIGH mode entered
11 0B BANK SELECT LOW mode entered
12 0C BUMP MODE ADD mode entered
13 0D BUMP MODE SOLO mode entered
14 0E BUMP MODE OFF mode entered
15 0F BUMP SCENE CHAN mode entered
16 10 BUMP SCENE PRES mode entered
17 11 STACK pressed
18 12 PRESET pressed
19 13 CHASE pressed
10 14 SETUP pressed
11 15 CHASE ON pressed
12 16 CHASE RUN pressed
13 17 CHASE SELECT pressed
14 18 CHASE STEP pressed
25 19 MODIFY pressed
26 1A WHEEL UP pressed
27 1B WHEEL DN pressed
28 1C CHASE STEP pressed
29 1D CHASE STEP released
25-31 19-1F not used, reserved for future UI events
32-47 20-2F Preset Page, bits 0-3 = page number
48-63 30-3F Chase Pattern, bits 0-3 = chase num
64-127 40-7F not used, reserved for future use
+
51 33 Next Cue LSB bits 0-6 = NEXT CUE bits 0-6
bit 7 = 0
52 34 Next Cue MSB bits 0-5 = NEXT CUE bits 7-12
bit 6 = 0, reserved for future use
bit 7 = 0
53 35 Not used, reserved for future use
54 36 Crossfade Slider 0-127
55 37 Master Slider 0-127
56 38 X Master 0-127
57 39 Y Master 0-127
58 3A Chase Level 0-127
59 3B Chase Rate 0-127
60 3C Y Scene Channel 1 FADER 0-127
61 3D Y Scene Channel 2 FADER 0-127
62 3E Y Scene Channel 3 FADER 0-127
| | | |