Leprecon LP-1600 Series - Manual (Page 50)

50
Pressing the MODIFY button to signify Yes will bring up the verification menu:
Are You Sure?
(REC = Yes)
Pressing the RECORD button will initiate the Show Load and cause the
following menu to be displayed:
Load Show ?
( * )
The “*” will bounce back and forth indicating that the file load is in progress. A
show will take from 1 to about 8 minutes to load, depending on how many of
the show entities (presets, chase steps, cues) have been programmed. If an
error occurs, such as “disk full”, “drive not ready”, or “disk write protected”,
etc., then an appropriate error message will be briefly displayed on the LCD,
such as:
Disk Error:
Drive Not Ready
Correct the cause of the error and attempt the operation again.
If a VGA display is attached, then when the Show Load commences, the
following progress screen will appear: