Leprecon LP-1600 Series - Manual (Page 42)

42
message:
CH Stp Loop at
5 1 1
3) Press the Record button. The display will show:
CH Stp Record
5 1 w/Select
4) Bring up the board channels that you wish to record as the first step. The
manual scenes, or Preset Masters may be used to set these levels.
5) Press the Select button for the chaser. This will record the first chase step,
and the display will verify this:
Ch Stp Recorded
5 1
The chase will automatically advance to the next step for recording.
6) Repeat steps 4 and 5 until the entire sequence, up to 20 steps, has been
recorded. When finished, press the Run button to end programming. The chase
will end with the last step recorded, and loop back to the start from that step.
6.4. Editing Chases
Individual channel levels in a chase step can be adjusted after the chase has
been recorded. The same editing features that are applied to the Preset
Memories and the Cue Stack can be used with the chaser.
To edit a chase step, first press the Chase menu button below the display. If
the chase is running, stop it by pressing the Chase Run button a second time.
The LCD will show:
Ch Stp Loop at
5 1 1
Press the Step button until the step you wish to edit is shown as the current
step on the display. If the chaser is on and the level is up, the step will also be
seen on stage.