Leprecon LP-1600 Series - Manual (Page 17)

17
The display shows the current output levels of all 48, 72 or 96 board channels.
Note that this is pre-patch information.
Along the left edge of the channel data is a green bar that brackets either the
lower or upper bank of channels. Pressing the BANK select switch will cause
the brackets at the left to alternate between lower and upper banks. Pressing
the Y/Presets button will cause the left-bracket’s title to alternate between “X”
and “X & Y”. While in “X & Y” mode, the board acts as a two-scene console,
with both X and Y faders piling on to form the output level. Changing
the left-bracket to “X” mode causes a second bracket to appear on the right
side of the display. The right-bracket is labeled “PRESETS”, and indicates that
the Y-faders are now acting as Preset faders.
Pressing the STACK menu button will cause that “button” to become
highlighted in the small window in the upper right corner of the screen. The
same is true when the PRESETS or CHASES button is pressed.