Leprecon LP-1600 Series - Manual (Page 44)

44
Press the Step button until the step that you wish to insert after is shown on
the display. In the previous example, with step 2 on the display, a new step
would be inserted between steps 2 and 3. The step that was previously on step
3 would be moved to step 4, and so on. The total length would increase by one
for each step inserted until the limit of 20 steps was reached. No new steps can
be added once this limit is reached.
Once the step is selected, rotate the data wheel to the right until the following
display is seen:
Ch Stp Insert
5 3 w/REC
Set the look on stage that is desired for the new step. The source can be
manual scene faders, or Preset Masters. Once the levels are set, press the
Record button once to insert the new step. The LP1600 will respond:
Inserted
Chase 5 Step 3
This message will remain for a few seconds, then be replaced with:
Ch Stp Insert
5 3 W/REC
Setting up and inserting a second cue at this time would insert it after the
previously inserted cue. The step number, or insertion point, can be changed at
any time by placing the cursor under the step number, holding down the
Modify button, and turning the data wheel.
Steps are deleted in a similar manner. Press the Chase menu button, and stop
the chaser if it is running. Set the chaser to the desired point with the Step
button, or use the data wheel. When the step to be deleted is shown as the
current step, turn the data wheel to the right until the following display is seen:
Ch Stp Delete
5 2 w/REC
In this case, step 2 would be deleted. The information programmed into step 3
would move down to replace the old step 2, and all other steps would also move
down. As a result, the pattern would be shorter by one step. Pressing the
Record button will delete the step, and the display will verify this action: