QuickLabel Vivo! Touch - Manual (Page 119)

Maintenance
Vivo! Touch User Guide 105
3 Pull the two blue fuser retaining levers towards the front of the printer so that they
are fully upright.
Warning: The fuser is always extremely hot when the printer is in use. Always lift the
fuser by the handle only. Use caution when handling the fuser.
Holding the fuser by its handle, lift the fuser straight up and out of the printer.
Place the fuser upright on a clean, flat surface away from any flammable materials.
4 Close the top cover of the Vivo! Touch. This will help reduce the amount of light
exposure to the image drums.
5
Wait at least 30 minutes for the fuser to cool down sufficiently to handle.
Warning: To avoid personal injury, do not attempt to clean the fuser while it is hot.
6 When the fuser has cooled, inspect it for excess adhesive. Use a pre-moistened
alcohol cloth to remove adhesive from the fuser surfaces and inside roller. Use the
white gear to turn the roller during cleaning.
When you are finished cleaning the fuser, let the alcohol dry.
7 Open the top cover of the Vivo! Touch.
8 Holding the fuser by its handle, ensure it is oriented correctly. The blue retaining
levers should be fully upright and the two locating lugs should be towards you.
Lower the fuser into the printer, locating the two lugs into their slots in the metal
partition that separates the fuser area from the image drums.
Push the two blue retaining levers towards the rear of the printer to lock the fuser
in place.
9 Close the top cover of the Vivo! Touch.