JVC GY-HC900STU 2/3" HD Connected Cam Studio Camcorder (Body Only) - Manual (Page 188)

Connecting to Network via Built-in
Wireless LAN u v 0
1 Configure the connection settings with
[Wizard].
0 Select “USB/Int. WLAN” in [Network]
B
[Connection Setup]
B
[Wizard], and
configure the settings according to the
instructions on the screen.
Perform setting for the following.
0
Mode of connection
0
Configuration method
* For P2P connections, it is necessary to
configure the [Default Gateway] and
[Passphrase] according to the steps below
after the above settings are configured.
A Set [Network]
B
[Connection Setup]
B
[Default Gateway] to “USB/Int. WLAN”.
B Set the camera recorder to the Camera
mode, and display the [USB/Int. WLAN]
(status) screen.
0 Press the [STATUS/SET] button on the
camera recorder to display the status
screen. Press the cross-shaped button
(
H I
) to display the [USB/Int. WLAN]
screen.
0 Check to ensure that the [SSID] and
[Passphrase] that you have set in the
wizard are displayed.
C
Select an SSID from the list of access
points (smartphone, tablet terminal, PC,
etc.) and enter a passphrase.
0 Display the list of access points in the
wireless connection settings of the
smartphone, tablet terminal, or PC, and
select “HC900-****”. (**** are numbers
that vary with the device used.)
0 After the password confirmation screen
appears, enter the [Passphrase]
displayed on the [USB/Int. WLAN]
screen.
2 Setting is complete.
After setting is complete, you can access the
camera recorder via a web browser.
Memo :
0 After setting is complete, the following items will
be automatically configured.
0
The [Network]
B
[Connection Setup]
B
[USB/
Int. WLAN] setting changes to “On”.
0
The [Network]
B
[Connection Setup]
B
[Default Gateway] setting changes to “USB/
Int. WLAN”. However, this does not apply to
the P2P connection.
0
The [Network]
B
[Live Streaming]
B
[Interface] setting changes to “USB/Int.
WLAN”.
188
Preparing Network Connection
Con
nectin
g to the Network