JVC GY-HC900STU 2/3" HD Connected Cam Studio Camcorder (Body Only) - Manual (Page 224)

Symptom Action
The [CH-1/CH-2] recording
level adjustment knob does
not work.
0 Is the [AUDIO SELECT CH1/2]-[MANUAL/AUTO] selection switch set
to “AUTO”?
0 Is Full Auto enabled?
Is [Camera Function]
B
[Full Auto]
B
[Audio] set to “Auto” in Full Auto
mode?
(
A
P115 [Full Auto Item] )
[CH-3/CH-4] audio is not
recorded.
0 Is the number of recording channels set to “4ch”?
Set [System]
B
[Record Set]
B
[ W Audio]/[ Y Audio] to “4ch”.
(
A
P153 [ W Audio ] )
Microphone audio cannot be
heard through the headphone.
0 Is the audio setting configured to “IFB/RET Only”?
Set [A/V Set]
B
[Audio Set]
B
[IFB/RET Monitor] to “Off”.
(
A
P138 [ IFB/RET Monitor... 0 ] )
SD card cannot be initialized
(formatted).
0 Is the write-protect switch of the SD card turned on?
Make sure that the write-protect switch is turned off.
(
A
P48 [Write-Protect Switch on the SD Card] )
Battery alarm appears even
after loading a charged
battery.
0 Is the battery too old?
The time code and user’s bit
are not displayed.
0 Even in Camera mode or Media mode, the time code and user’s bit
may not be displayed depending to the type of display.
0 Is [LCD/VF]
B
[Display On/Off]
B
[TC/UB] set to “Off”? To display the
date and time, set it to “On”.
(
A
P130 [Display On/Off Item] )
The time is not displayed. 0 The time is only displayed on the display screen in the Camera mode
(during shooting).
(
A
P161 [Display Screen in Camera Mode] )
0 Is [System]
B
[Record Set]
B
[Time Stamp] set to “On”? To display
the date and time, set it to “Off”.
(
A
P156 [ Time Stamp ] )
The actual recording time is
shorter than the estimated
time.
0 The recordable time may be shorter depending on the shooting
conditions or the subject.
The two camera recorders are
not synchronized even though
the time codes have been
synchronized. ( Z on the Slave
device is not displayed.)
0 Is the [TC GEN] switch set to “F-RUN”?
(
A
P78 [Synchronizing the Time Code with an External Time Code
Generator] )
0 Set [System]
B
[Record Set]
B
[Record Format]
B
[ W Frame Rate]
such that the two camera recorders have the same frame rate.
(
A
P152 [ W Frame Rate ] )
Cannot connect to wireless
LAN.
0 Check the mode of connection and method of setting ([SSID] and
[Passphrase] in cases other than WPS).
(
A
P187 [Connecting to Network via [HOST] Terminal (USB) 0 ] )
(
A
P188 [Connecting to Network via Built-in Wireless LAN u v
0 ] )
0 Even if the Passphrase is wrong, “Completed the Setup Wizard.
Please Input the Passphrase into Your Device.” may appear at the
browser setting depending on the type of encryption.
Adjust [Passphrase] again.
0 Set [Network]
B
[Connection Setup]
B
[Default Gateway] to a value
other than “LAN”.
(
A
P140 [ Default Gateway ] )
224
Troubleshooting
Others