Innotech Genesis V4 System - Manual (Page 12)

Installation Instructions for Innotech Genesis Systems
Edition 011100 1-2
The purpose of this manual is to provide clear and complete instructions for all phases of the
installation of the units that comprise your Genesis System. In order to provide the clearest
instructions possible with minimum confusion, instructions in this manual are based on the
following approach:
•
For simplicity of explanation, installation instructions in this manual are based on the
assumption the system to be installed is a typical Genesis II System containing a single
Genesis II Digital Controller and the three types of LEMs. Installation information for
other configurations, such as a Genesis I System or a Genesis II System controlled by a
GENII MPC is also provided as additional data.
•
Instructions for REMs and RMIs are the same as for LEMs, except where otherwise noted.
Difference data, if required, is included in each section.
•
Data Sheets in Appendix B of this manual contain information needed for installation of
miscellaneous ancillary units. Separate instructions for these units are not provided in the
main part of the manual unless the data is not available on the Data Sheets.
•
Basic electrical wiring information is provided in Section 3 and wiring instructions for
network systems is contained in Appendix A.
1-1.2. SCOPE OF THIS TECHNICAL MANUAL. This technical manual
contains:
•
SECTION 1 – PRELIMINARY INFORMATION
•
SECTION 2 – MECHANICAL INSTALLATION
•
SECTION 3 – ELECTRICAL INSTALLATION
•
SECTION 4 – COMMISSIONING
•
APPENDIX A – NETWORK INSTALLATION
•
APPENDIX B – GENESIS SYSTEM DATA SHEETS
This section of the manual contains installation-related information of a general nature such as
general safety considerations and pre-installation requirements.
Section 2 contains instructions and related data to facilitate the mechanical installation of
components of the Genesis System. Section 2 includes such information as physical
descriptions of the units, mounting dimensions and mechanical installation guidelines.
Section 3 is the ELECTRICAL INSTALLATION section and contains electrical wiring
information useful for installation of a basic “stand-alone” system. Section 3 is augmented by
network wiring information in Appendix A. Appropriate references are provided between
Section 3 and Appendix A for installation of network wiring.
Section 4, the COMMISSIONING Section, provides instructions for post-installation
inspection and checkout of the Genesis System, power application and initial set-up of the
various units that comprise the system.
Appendix A. provides detailed information for interconnecting various units in a network
configuration. This appendix should be used in conjunction with Section 3 when network
installation is involved. The two electrical installation areas: Section 3 and Appendix A are
purposely separated from each other in the interest of clarity and to simplify use of the manual.