Innotech Genesis V4 System - Manual (Page 27)

Installation Instructions for Innotech Genesis Systems
Edition 011100 3-1
SECTION 3- ELECTRICAL INSTALLATION
3-1. INTRODUCTION.
This section of the manual contains instructions and related data to facilitate the electrical
installation of the Genesis I or Genesis II System. Because of the electrical similarities of the two
systems, instructions contained in this section apply equally to the Genesis I and Genesis II
Systems, except where otherwise noted.
Because of the designed-in flexibility of the Genesis System, it can be installed in a wide variety
of configurations, depending on the user’s preference. For this reason it is not possible to include
all the various installation configurations in this manual. Instead, this manual provides examples
of installations that are considered typical. Innotech recognises that the installation examples
described in this manual may not be in total agreement with the user’s requirements. However,
information in this document should be used as a guide for all installations, regardless of whether
the specific circumstances match the examples given. In all cases, installation personnel should
familiarise themselves with the information contained in this section.
NOTE
If required, additional installation recommendations can be obtained
from Innotech Control Systems Australia upon request.
This section of the technical manual contains the following specific information:
•
Electrical Installation Practices of a general nature
•
Wiring information for controllers (Genesis I and II Digital Controllers and Genesis II Mid
Points Controller)
•
Wiring information for expansion modules (Local Expansion Modules and Remote
Expansion Modules)
3-2. ELECTRICAL INSTALLATION PRACTICES.
This paragraph provides general information useable to qualified personnel installing the Genesis
Systems. More detailed information for wiring of controllers and expansion modules is contained
in subsequent paragraphs.
All wiring between the controller/expansion modules and system input/output devices, such as
sensors, fans, compressors, must be in accordance with the instructions in the applicable
instruction manual or data sheet.
CAUTION
ELECTRICAL POWER TO THE SYSTEM MUST BE TURNED
OFF THROUGHOUT THE INSTALLATION PROCESS. DO NOT
APPLY POWER TO ANY PART OF THE SYSTEM UNTIL READY
FOR COMMISSIONING (SEE SECTION 4).