Innotech Genesis V4 System - Manual (Page 13)

Installation Instructions for Innotech Genesis Systems
Edition 011100 1-3
Individual systems may include hardware items that are not represented in this manual. In
such cases, data sheets for the items are included in Appendix B. The contents of Appendix B
are different for each system configuration. Appendix B in your technical manual contains
only data sheets, if any, that are applicable to your system.
1-2. SPECIAL CONSIDERATIONS.
The following precautions and installation considerations must be observed to ensure personal
safety and to prevent damage to equipment.
•
Local safety regulations, building codes and ordinances must be complied with during
installation. In cases of conflict with procedures in this manual, contact Innotech or its
authorised representative for clarification.
•
To prevent damage to equipment, avoid applying electrical power to the equipment prior to
checkout, unless specifically instructed to do so in this manual.
•
The Genesis System can be installed using common tools and test equipment. Only qualified
personnel, familiar with local codes and practices should install the system. Wiring should
only be performed by someone knowledgeable of electronics and wiring installation
practices. Refer to the appropriate documentation when installing items provided by other
manufacturers
1-3. UNPACKING INSTRUCTIONS.
The following unpacking instructions should be followed as soon as possible after the equipment
is delivered to the installation site:
a. Carefully unpack each item and set packing materials aside for future use.
b. Check the inventory against the packing list to make sure nothing is missing.
c. Inspect each item for damage.
d. Report any shortages or damaged items.
e. Collect all factory inspection sheets and similar data; place in an equipment history file.
f. Any items that are not to be installed immediately should be carefully returned to its
shipping container and stored in a safe place until 8t is time for it to be installed.
1-4. INSTALLATION PLANS.
The following installation data should be gathered and made available to the installation team:
•
This Technical Manual.
•
Computer-Generated Wiring Diagram - the Genesis configuration software can be used to
print a wiring diagram for the specific application. A copy of this wiring diagram is usually
provided at the time of hardware delivery. Procedures for printing additional copies of the
wiring diagram are contained in the Innotech Genesis II Direct Digital Controller User
Manual.