Innotech Genesis V4 System - Manual (Page 22)

Installation Instructions for Innotech Genesis Systems
Edition 011100 2-8
Figure 2-8. Typical Enclosure Layout.
2-3.1. DIN RAILS. The DIN rail is an industry-standard item and is available from a
large number of commercial sources. The rail is usually manufactured from galvanised steel
and may be provided with a finish. It is typically available in 2-metre lengths. DIN rail cutters
are available commercially and are recommended; however, for smaller installations, a
hacksaw may be used to cut the rails to the required length. Figure 2-9 is provided to assist in
planning layout of the LEMs; the figure shows the dimensions of a typical DIN rail section.
GENESIS II
R
D.I.M. D.I.M. D.O.M. D.O.M.
45mm Slotted Cable Duct
45mm Slotted Cable Duct
45mm
S
lott
ed C
abl
e D
u
ct
45mm
S
lott
ed C
abl
e D
u
ct
45mm Slotted Cable Duct
A.I.M.
Panel Size
600 X 900mm
Terminal Strip
Digital
Controller
Power
Transformer
Auxiliary
Power
Transformer
Standard Power
Point (Outlet)
See Note
See Note
See Note
65mm Space Between Duct
and Terminals in These Areas.
NOTE: