Innotech Genesis V4 System User Manual
Page 16
Installation Instructions for Innotech Genesis Systems
Edition 011100
2-2
plastic base has eight mounting holes; each hole is 4mm in diameter. Not all of the eight
holes are required for mounting, providing the unit is securely installed.
There are four slots in the bottom circuit board (motherboard) - two slots at each end.
These slots facilitate the clamping of the plastic lid to the motherboard. To remove the
plastic lid from the motherboard, press firmly inwards at each end of the plastic lid-piece to
disengage the clip-in fitting and lift away simultaneously (see Figure 2-1). Installation of
the plastic lid is similar to the removal procedure; insert the clip-in fitting at one end of the
plastic lid into the slots provided on the motherboard. Then, clip the opposite end of the
plastic lid into the slots at that end of the motherboard. Pressing the two ends of the plastic
lid together can assist in the operation.
The Digital Controller’s outline dimensions are shown in Figure 2-2.
Figure 2-1. Digital Controller Plastic Lid Clamping Details.
Figure 2-2. Digital Controller Dimensions.
Plastic Lid Piece
Top Circuit Board
Motherboard
Plastic Base Piece
PRESS TO
RELEASE
308
292
280
140
180
50
50
12
25
ALL DIMENSIONS ARE IN MILLIMETRES
Mounting Hole
4mm
Typical of 8