1.4.3. analogue output jumpers, Rs485 comms connections end-of-cable jumper – Innotech Genesis V4 System User Manual
Page 75
Installation Instructions for Innotech Genesis Systems
Edition 011100
4-20
Figure 4-6. Address Jumpers, Typical Settings.
Figure 4-7. End-of-Cable Jumper, Typical Location.
4-1.4.3.
Analogue Output Jumpers.
An analogue output jumper plug arrangement
is provided for each analogue output channel. The three-pin jumper sockets will accept a
shorting plug between the centre pin and either of the outside pins. Depending upon which
pair of pins the jumper is connected to, the analogue output is configured for either the
Variable Mode or the Heat Valve Mode. For inactive analogue output channels, the jumper
is not installed in either position. In such cases the jumper plug can be conveniently stored
in the unit by inserting only one end of the plug into the socket.
1
2
3
J
I
H
G
F
E
D
C
B
A
A
I5
A
I6
A
I7
A
I8
A
I9
+
+
+
+
+
-
-
-
-
-
Sensor #7
Sensor #11
Sensor #10
Sensor #9
Sensor #8
Address
jumpers
A
0
A
1
A
1
<
n
o
t u
s
e
d
>
A
2
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
JUMPER
OPEN
PORTION OF COMPUTER-GENERATED WIRING
DIAGRAM SHOWING ANALOGUE INPUT MODULE
GEN II AI REM
1 2 3
RS485 COMMS
CONNECTIONS
END-OF-CABLE
JUMPER