Innotech Genesis V4 System User Manual

Page 52

Advertising
background image

Installation Instructions for Innotech Genesis Systems

Edition 011100

3-26

Table 3-16. DO REM Relay Output Signal Connections.

TERMINAL

SIGNAL

TERMINAL

SIGNAL

NORMALLY OPEN (NO)

COMMON (C)

A

Relay 1

B

Relay 1

C

Relay 2

D

Relay 2

E

Relay 3

F

Relay 3

G

Relay 4

H

Relay 4

I

Relay 5

J

Relay 5

3-4.2.9.

CS REM Control Station Module.

The CS REM mounts into a standard

electrical wallplate. The only connections to the CS module are 24Vdc power and the
RS485 Comms link. Locations of electrical terminals are shown in Figure 3-14, which is a
rear view of the module.

When all connections have been made, protect the module from dirt and moisture by
covering it with plastic but do not mount the module in the wall plate until commissioning
is completed. This is to allow addresses to be set as part of the commissioning process.

Figure 3-14. CS REM Control Station Module.

3-4.2.10.

MZS REM Multi Zone Station Module.

The MZS REM is similar

to the CS REM in appearance and locations of connection points. Power and RS485
connection requirements are the same as for the CS REM.

3-4.2.11.

MP REM Multipoint Module.

The MP REM (Figure 3-15) is a remote

expansion device that has both input and output expansion capabilities. The MP REM
provides relay outputs for distributed control, digital inputs for status detection and
thermistor inputs for temperature measurement. This module is mainly used in applications
requiring remote control of fan/coil units using relay outputs for fan control and a
thermistor for measuring air temperature.

1 2 3

24V

0V EARTH

RS485

COMMS

TERMINALS

END OF

CABLE

JUMPER

POWER

MODULE VIEWED FROM REAR

Advertising