Innotech Genesis V4 System - Manual (Page 58)

Installation Instructions for Innotech Genesis Systems
Edition 011100 4-3
Table 4-1. Genesis System Power Inputs.
OPERATING VOLTAGE
UNIT
24Vac
10%
24Vdc
10%
240Vac
GENESIS II Digital Controller Note 1
GENESIS I Digital Controller Note 1
GENII AIM Analogue Input Module (LEM) Note 2
GENII DIM Digital Input Module (LEM) Note 2
GENII DOM Digital Output Module (LEM)
GENII RPTR Repeater Module
GENII MPC Mid Points Controller Note 1
GENII RMI Remote Module Interface Note 2
GENII AI REM Analogue Input Modula
GENII AO REM Analogue Output Module
GENII IDI REM Opto-Isolated Digital Input Module
GENII DI REM Dry Contact Digital Input Module
GENII DO REM Relay Output Module
GENII CS REM Control Station Module
GENII MP REM Multipoint Module
GENII MZS REM Multi Zone Station Module
NOTES:
1.
Optional 24Vdc supply is available.
2. Unit receives operating power from the controller by way of the LEM/RMI Cable.
WARNING
THE POWER INPUT TO THE GENII MP REM MULTIPOINT
AND GENII RPTR MODULES IS 240VAC.
TO PREVENT
PERSONAL INJURY OR DEATH FROM ELECTRICAL SHOCK,
DO NOT ATTEMPT TO PERFORM THE FOLLOWING
PROCEDURES ON THE MP REM AND RPTR MODULES. SINCE
THESE MODULES PLUG INTO STANDARD ELECTRICAL
POWER POINTS, A VOLTAGE CHECK AT THE UNIT IS
UNNECESSARY UNLESS A POWER MAINS FAILURE IS
SUSPECTED. SUSPECTED POWER MAINS FAILURES SHOULD
BE REFERRED TO A QUALIFIED ELECTRICIAN.