Lenze PC-based Automation Industrial PC - Manual (Page 165)

2.5 EN - 01/2012
L
165
Industrial PC | Parameter setting & configuration
Parameter reference
Industrial PC extension modules
Parameters of interface 2, card has been installed in slot 1
C1113
C1121
C1122
C1130
C1131
Parameter | Name:
C1113 | Device: Driver index
Data type: UNSIGNED_32
Index: 23462
d
= 5BA6
h
Index of the device driver. Since there can be more than one CAN interface, several instances can be run via the
driver.
Display range
(min. value | unit | max. value)
; Read access Write access CINH PLC STOP No transfer
Parameter | Name:
C1121 | Sync master: Interface index
Data type: UNSIGNED_32
Index: 23454
d
= 5B9E
h
Note: Restart the IPC after changing this parameter!
Setting range
(min. value | unit | max. value) Lenze setting
4294967295
; Read access ; Write access CINH PLC STOP No transfer
Parameter | Name:
C1122 | Baud rate
Data type: UNSIGNED_32
Index: 23453
d
= 5B9D
h
Baud rate of the CAN interface. The value is assigned from a selection list.
Selection list
(Lenze setting printed in bold)
7 5
6 10
5 20
3 50
8 100
2 125
1 250
0 500
4 1000
; Read access ; Write access CINH PLC STOP No transfer
Parameter | Name:
C1130 | Tx PDO counter
Data type: UNSIGNED_32
Index: 23445
d
= 5B95
h
PDO counter for sent CAN messages
Display range
(min. value | unit | max. value)
; Read access Write access CINH PLC STOP No transfer
Parameter | Name:
C1131 | Rx PDO counter
Data type: UNSIGNED_32
Index: 23444
d
= 5B94
h
PDO counter for received CAN messages
Display range
(min. value | unit | max. value)
; Read access Write access CINH PLC STOP No transfer