Lenze PC-based Automation Industrial PC - Manual (Page 182)

Industrial PC | Parameter setting & configuration
Parameter reference
Industrial PC extension modules
182
L
2.5 EN - 01/2012
C1096/9
C1096/10
C1096/11
Parameter | Name:
C1096/9 | ECAT config.: Physical address
Data type: UNSIGNED_16
Index: 23479.9
d
=
0x5BB7.0x09
h
The physical address of the slave set in the master configuration file
This address is specified by the »PLC Designer« and assigned consistently in ascending order, starting with 1001.
Display range
(min. value | unit | max. value)
0 65536
; Read access Write access CINH PLC STOP No transfer
Parameter | Name:
C1096/10 | ECAT: Alias address
Data type: UNSIGNED_16
Index: 23479.10
d
=
0x5BB7.0x0A
h
Alias addresses are addresses directly saved on the device (e.g. via DIP switches)
At present our system does not support alias addresses.
Display range
(min. value | unit | max. value)
0 65536
; Read access Write access CINH PLC STOP No transfer
Parameter | Name:
C1096/11 | ECAT: Port state
Data type: BITFIELD_16
Index: 23479.11
d
=
0x5BB7.0x0B
h
Display of the port states/connections (ports 0 ... 3) of a slave
The structure is bit-coded (WORD).
Value is bit-coded:
Bit 0 Port 0 1 (TRUE) = Slave is
connected (logic result of
bits 0 ... 11)
Bit 1 Port 1
Bit 2 Port 2
Bit 3 Port 3
Bit 4 Port 0
1 (TRUE) = Link is known
Bit 5 Port 1
Bit 6 Port 2
Bit 7 Port 3
Bit 8 Port 0
1 (TRUE) = Loop is closed
Bit 9 Port 1
Bit 10 Port 2
Bit 11 Port 3
Bit 12 Port 0
1 (TRUE) = Signal received
Bit 13 Port 1
Bit 14 Port 2
Bit 15 Port 3
; Read access Write access CINH PLC STOP No transfer