Lenze PC-based Automation Industrial PC - Manual (Page 172)

Industrial PC | Parameter setting & configuration
Parameter reference
Industrial PC extension modules
172
L
2.5 EN - 01/2012
14.6.2 EtherCAT communication card (MC-ETC)
In this chapter all parameters of the IPC EtherCAT MC-ETC communication card are listed
in numerically ascending order.
Card parameters in slot 1
C1031
C1032
C1033
C1034
C1035

Note!
EtherCAT is not available for Industrial PCs of the device series EL 1xx, EL x8xx,
CS x8xx and CPC x8xx in combination with the Control technology release 2.5.

Note!
• An Industrial PC can maximally have one MC-ETC communication card.
Irrespective of the slot the card has been installed in, the card's name in the
»WebConfig«
is MC-ETC1.
• Depending on the used slot, the code numbers differ by an offset of '500'. So
for a communication card in slot 2, an offset of '500' has been added to the
code numbers of a slot 1 card.
Parameter | Name:
C1031 | Device: Type key
Data type: VISIBLE_STRING
Index: 23544
d
= 5BF8
h
Card identification
; Read access Write access CINH PLC STOP No transfer
Parameter | Name:
C1032 | Device: Type version
Data type: VISIBLE_STRING
Index: 23543
d
= 5BF7
h
Version number of the card
; Read access Write access CINH PLC STOP No transfer
Parameter | Name:
C1033 | Device: Name
Data type: VISIBLE_STRING
Index: 23542
d
= 5BF6
h
Device name of the card
; Read access Write access CINH PLC STOP No transfer
Parameter | Name:
C1034 | Device: Software version
Data type: VISIBLE_STRING
Index: 23541
d
= 5BF5
h
Software version of the card
; Read access Write access CINH PLC STOP No transfer
Parameter | Name:
C1035 | Device: Hardware version
Data type: VISIBLE_STRING
Index: 23540
d
= 5BF4
h
Hardware version of the card
; Read access Write access CINH PLC STOP No transfer