3 parameters with a bit-coded setting, 4 parameters with subcodes, Parameters with a bit-coded setting – Lenze PC-based Automation Industrial PC User Manual
Page 43: Parameters with subcodes
Advertising
2.5 EN - 01/2012
L
43
Industrial PC | Parameter setting & configuration
Parameterisation using the L-force »Engineer«
Representation of the parameters
6.4.2.3
Parameters with a bit-coded setting
The »Engineer« uses a dialog box for the parameter setting in which the individual bits
can be set or reset. Alternatively, the value can be entered as a decimal or hexadecimal
value:
6.4.2.4
Parameters with subcodes
In the »Engineer« parameter list each subcode is itemised individually.
Advertising