Lenze PC-based Automation Industrial PC - Manual (Page 56)

Industrial PC | Parameter setting & configuration
Web-based parameterisation with »WebConfig«
User interface
56
L
2.5 EN - 01/2012
7.4.6 General parameters
7.4.7 Extension card parameters
This area of the »WebConfig« gives on overview of the parameters of the installed
extension cards. The Industrial PC is able to support a maximum of two communication
cards at the same time. The following communication cards can be applied:
 MC-CAN2,
 MC-ETC,
 MC-PBM,
 MC-ETH.
A distinction is drawn between:
– Interface parameters,
– Communication card parameters.
A communication card can be equipped with several physical bus interfaces, such as the
MC-CAN2 communication card.
 CAN communication card (MC-CAN2)
( 162)

EtherCAT communication card (MC-ETC)
( 172)
 PROFIBUS master communication card (MC-PBM)
( 207)
 Ethernet communication card (MC-ETH)
( 209)
Button Function
Displays the parameters for setting the time, date, system time, and time
zone.
Displays the UPS settings for the parameterisation of optional
UPS accessories.
Displays hardware/temperature data.
Displays information on program/Flash memories.
Displays information on system identification.