Lenze PC-based Automation Industrial PC - Manual (Page 184)

Industrial PC | Parameter setting & configuration
Parameter reference
Industrial PC extension modules
184
L
2.5 EN - 01/2012
C1096/17
C1096/18
Selection list (read only)
0 Unknown
1 Init
2 Pre-Operational
4 Safe Operational
8 Operational
; Read access Write access CINH PLC STOP No transfer
Parameter | Name:
C1096/16 | ECAT: Current state
Data type: UNSIGNED_32
Index: 23479.16
d
=
0x5BB7.0x10
h
Parameter | Name:
C1096/17 | ECAT: Active error
Data type: UNSIGNED_8
Index: 23479.17
d
=
0x5BB7.0x11
h
• Value "0": No error
• Value "1": An error is active
Display range
(min. value | unit | max. value)
0 1
; Read access Write access CINH PLC STOP No transfer
Parameter | Name:
C1096/18 | ECAT: Activate link messages
Data type: UNSIGNED_8
Index: 23479.18
d
=
0x5BB7.0x12
h
Debug parameter:
If the parameter is set to value "1", all state changes of the slave will be output in the form of a diagnostic frame via
the Ethernet interface. In the event of an error, a wireshark record can be used for error diagnostic purposes.
(»Wireshark«: Program for the analysis of network communication links)
• Value "0": No link messages
• Value "1": Activate link messages
Setting range
(min. value | unit | max. value) Lenze setting
0 1 0
; Read access ; Write access CINH PLC STOP No transfer