Lenze PC-based Automation Industrial PC - Manual (Page 80)

Industrial PC | Parameter setting & configuration
Replacing the Industrial PC
Connecting the new Industrial PC
80
L
2.5 EN - 01/2012

How to remove the connected Industrial PC:
1. Disconnect the system from the supply and check for correct disconnection.
2. Remove the current supply from the Industrial PC.
3. Remove bus connections and other connections.
4. Dismount the Industrial PC using appropriate tools.
5. Remove the Compact Flash card from the Compact Flash drive.
6. Remove the »VisiWinNET®« dongle (if plugged in).
11.2 Connecting the new Industrial PC

How to install and connect a new Industrial PC:
1. Use a new Industrial PC of the same product type.
2. Insert the Compact Flash card of the removed Industrial PC into the new Industrial
PC.
3. Mount the Industrial PC using appropriate tools.
4. Connect bus connections and other connections.
5. Connect the Industrial PC to the current supply.
6. Switch on the voltage supply.
• The new Industrial PC boots up.

Note!
When connecting a new Industrial PC
• all cards are to be kept in the same slot,
• all connections are to be connected identically.

Note!
The compact flash card contains all data.
If an Industrial PC of the same product type has been used, the Industrial PC is
ready for operation after boot-up.
• The network configuration has remained stored and has to be confirmed.
– After 15 seconds the previous IP address is accepted automatically and the
touch calibration is skipped.
Now the Industrial PC can be reached again.