Lenze PC-based Automation Industrial PC - Manual (Page 38)

Industrial PC | Parameter setting & configuration
Parameterisation using the L-force »Engineer«
Parameterisation via codes
38
L
2.5 EN - 01/2012
6 Parameterisation using the L-force »Engineer«
This chapter provides information on how to configure the Industrial PC using the
L-force »Engineer«. Further information on the settings in the »Engineer« is provided in the
corresponding topics of the online help.
6.1 Parameterisation via codes
 All settings by means of which you parameterise the Industrial PC are summarised in a
parameter list that is numbered serially. The individual entries of this list are called
"codes". Each code can be addressed via a number.
 Codes can also contain subparameters. They are also numbered and can be addressed
via a subindex. With the code number and the subindex you can address each
parameter unambiguously.


Tip!
In addition to the parameterisation via the »Engineer«,
you can also parameterise the Industrial PC by means of the »WebConfig«.
The web-based parameterisation can be found in the chapter
 Web-based parameterisation with »WebConfig«
( 44)
The parameter lists can be found in the chapters entitled
 Parameter reference
( 125)