Figure 61, Figure 62, Connect i/o signal window – Vaisala Hydromet Data Collection Platform User Manual
Page 117
Chapter 3 _____________________________________________ Configuring Modules and Sensors
VAISALA______________________________________________________________________ 115
2.
Proceed to the Equipment or Additional sensors view to add and
connect the sensor as shown in
.
0711-148
Figure 61
Equipment View: Adding and Connecting Serial
Sensor
The first number of the connector identifier MODX/X (for
example, MOD1/1) indicates the piggyback slot: 1 is the one closer
to the battery holder and 2 is the bottom one. The second number
is present only if you are using a dual port board such as DSU232
or DSI486. It indicates the channel number, 1 or 2.
3.
If you are connecting multiple sensors to the same serial line, the
following window opens. Click Yes.
0711-149
Figure 62
Connect I/O Signal Window
NOTE
Serial sensors do not have default connectors, so you need to connect
the sensor manually to the selected port.