Figure 22 – Vaisala Hydromet Data Collection Platform User Manual
Page 60
User's Guide ______________________________________________________________________
58 __________________________________________________________________ M210933EN-C
3.
Give the Nokeval command, excluding the data value, directly
after the address. Note that you may not enter a space or any other
character between the address and the command. For detailed
information about valid commands, refer to the appropriate
Nokeval user manual at www.nokeval.com.
The subsequent field(s) contain the data value(s) of the command.
These may be, for example, measurement or calculation results.
For details about invalid data handling and scaling of data, see
section
Handling of Invalid Data on page 59
.
The ETX character and the checksum are automatically added to
each command by the QML logger, and therefore they are not
allowed to be included in the report.
4.
Proceed to the Communications view.
5.
Link the reports to the Nokeval converter as shown in
.
0711-119
Figure 22
Communications View: Connecting the Report
to Nokeval 7470