Vaisala Hydromet Data Collection Platform - Manual (Page 158)

User's Guide ______________________________________________________________________
156 _________________________________________________________________ M210933EN-C
The interface allows processing of remote maintenance commands as
listed in
Table 25 on page 199 . To enable the use of remote commands,
proceed as follows:
1. Select the Process inbound messages option.
2. Under Command processing, select Extparser in the Command
parser field.
3. If you want to receive responses to commands, select also the Send
responses to commands option.
Timeout 2000 ... 30000 ms Timeout for the communication
between QML logger and the
communicator
Options GPS receiver Communicator is equipped with GPS
Clear queue on
startup Clears transmission queue upon
startup
Clear queue if full Clears transmission queue if it
becomes full
Priority mask lo
Priority mask hi Priority mask for communications (do
not modify)
Process inbound
messages QML logger polls and processes
inbound messages as remote
commands
Send responses to
commands QML logger sends responses to the
inbound commands
Extra op. info to
COM0 Sends extra operation information to
COM0 for troubleshooting
Time
adjustment
tolerance -1 = disable
1 ... 3600 s When the current system time differs
from the GPS time more than the
tolerance set with this parameter, the
system time is adjusted to match the
GPS time
Parser
component
2
Empty, <None>, or
Extparser Parser used to process remote
commands
1. The maximum length of the user data is 229 characters for the globalgram
message type, while with enhanced globalgram recipient the subject and
message body can have 225 characters in total.
2. Visible only in advanced Lizard operation mode.
Table 14 ORBCOMM Communicator Parameters in Lizard
(Continued)
Parameter Value Description