Vaisala Hydromet Data Collection Platform - Manual (Page 209)

Chapter 5 __________________________________________ Configuring TCP/IP-Based Telemetry
VAISALA______________________________________________________________________ 207
Common configuration parameters for modem controls are listed in
Table 27 on page 207 . All parameters may not be applicable for a
certain modem type.
The lowest part of the view provides an interface for managing modem
commands and responses. For configuration instructions, refer to
section
Generic IP Modem Configuration on page 275 .
Table 27 Modem Control Parameters
Parameter Use
Command delay Delay in milliseconds between
successive commands.
Escape delay Delay in milliseconds between
escape characters (+) used when
closing the connection.
Dial retry count Number of retries if opening the
connection fails.
Dial retry delay Delay in milliseconds after a failed
connection attempt before attempting
a new connection.
Options/Reset after failure Use power control output to reset the
device after failure.
Options/Preserve power Keep modem powered only with
active connection.
Options/Answer incoming Answer incoming calls.
Options/Debug output Provide additional operation
information to COM0.
Power control Power control component
Powering delay Delay in milliseconds between
modem power-up and the first
command.
Carrier detect input Optional input component used to
monitor the carrier detect signal from
the modem.
Carrier detect variable Variable to monitor in the carrier
detect component.
Mask value for CD status Mask logically ANDed with value of
the carrier detect variable. If not set,
value 0 = CD off, else CD ON.