Vaisala Hydromet Data Collection Platform - Manual (Page 284)

User's Guide ______________________________________________________________________
282 _________________________________________________________________ M210933EN-C
3. Define the command exchanges associated with the different
states. The parameters for a command exchange are presented in
Table 53 on page 282 .
4. As needed, adjust the order of execution as described in section
Generic IP Modem Configuration on page 275 .
Table 53 Parameters for Modem Command Exchange
Parameter Use
Type Selection if executed when entering or exiting
the state.
State name Name of the state in which the command
exchange is executed.
Command to send One of the defined commands to send.
Expected response Name(s) of expected response(s). The list may
be empty, that is, no response, or it may
contain multiple responses separated by
commas. Do not enter the modem response
string(s) here, but use the response names
defined in the previous step. Make sure that
you type the name(s) correctly, including
upper/lower case. List also the error
responses; otherwise, they will exit only
through a timeout.
Conditional response Name of the previous response for conditional
execution, that is, this command exchange will
be executed only if the previously received
response matches the given response. For
example, the PIN code setting for GSM
modem will be executed only if the previous
response indicates that it is needed. For an
example, see the command exchange
AT_pinset for device Siemens GPRS-IP in
Lizard Setup Software.
Timeout Timeout for the command in milliseconds.
Retries Number of retries in case of failure.
Options Negate conditional = Execute only if the
previous response was not the given one;
Ignore error = ignore error responses.