Vaisala Hydromet Data Collection Platform - Manual (Page 153)

Chapter 4 ________________________________________________ Configuring Telemetry Options
VAISALA______________________________________________________________________ 151
port at the module place MOD1, type open DSU232_0_0. To
terminate this operation, type close. While the direct connection to
the modem or sensor is open, any automatic operation through the
connected port is blocked. Typical parameters for the open
command are presented in
Table 13 on page 151 . Information
concerning the correct connector can be obtained in Lizard in the
I/O Connections frame of the Equipment view.
Table 13 Parameters for the Open Command
Connector in Lizard Parameter Alias
COM0 COM0 COM0
COM1 COM1 COM1
DMX501 (MOD1/1) DMX501_0 MOD1
DMX501 (MOD2/1) DMX501_1 MOD2
DSI485A (MOD1/1) DSI485_0 MOD1
DSI485A (MOD2/1) DSI485_1 MOD2
DSI486 (MOD1/1) DSI485_0_0 MOD1_2
DSI486 (MOD1/2)
DSI486_0_1 1
1. With the dual RS-485 module, the RS-232 connection is possible only to
the channel B on the module, and thus the last number is 1.
MOD1_1
DSI486 (MOD2/1) DSI486_1_0 MOD2_2
DSI486 (MOD2/2)
DSI486_1_1 1 MOD2_1
DSI486SDI (MOD1/3) DSI486SDI_0 MOD1_3
DSI486SDI (MOD2/3) DSI486SDI_1 MOD2_3
DSU232 (MOD1/1)
DSU232_0_0 2
2. With the RS-232 and dual RS-485 modules, the number between the
underline characters stands for the module place, that is, MOD1 or MOD2,
and the last number for the channel on that particular module.
MOD1_1
DSU232 (MOD1/2) DSU232_0_1 MOD1_2
DSU232 (MOD2/1) DSU232_1_0 MOD2_1
DSU232 (MOD2/2) DSU232_1_1 MOD2_2
DSU232SDI (MOD1/3) DSU232SDI_0 MOD1_3
DSU232SDI (MOD2/3) DSU232SDI_1 MOD2_3
NOTE Use the SYSINFO PORTS command to find out which connectors to
use.