Vaisala Hydromet Data Collection Platform - Manual (Page 118)

User's Guide ______________________________________________________________________
116 _________________________________________________________________ M210933EN-C
4. Proceed to the Measurements view to configure the sensor
interface as shown in
Figure 63 on page 116 .
0711-150 Figure 63 Measurements View: Configuring Serial Sensor
Interface
Typical items to configure include the following:
Item Description/Use
Device ID Device identifier (must be entered)
- Same as the set
- Unique for each sensor if multiple devices are
connected to the same serial line
Used by
- Polling and data reception to identify the device
- Open commands to identify which device should
open its service interface
Mode Configuration for automatic or polled operations as
described in section
Data Acquisition Methods on page
110 .
Message
Type Many devices support data messages with different
contents. This item selects the expected message type.