Vaisala Hydromet Data Collection Platform - Manual (Page 176)

User's Guide ______________________________________________________________________
174 _________________________________________________________________ M210933EN-C
Transmitter Configuration
The configuration parameters of the transmitter are set through the
service terminal with the following command:
CFG <name> <parameter> <value>
A response to the command can be received by giving the command
LASTVAL <name> service. The response can be either
ID set , ID
set failed
,
Clock set
, or
Clock set failed
.
After power-up, before any transmissions can be made, the clock must
be set if the transmitter does not have an embedded GPS. The
transmitter ID stored to EEPROM is used after the power-up. If no ID
has been stored, one must be set before any transmissions can be made.
where
CFG = Configuration command
name = Transmitter name as given in Lizard; for example,
GOES_1
parameter = Any of the items in the Parameter column in Table 18
on page 174
value Any of the items in the Value column in Table 18 on
page 174
Table 18 Transmitter Configuration Parameters
Parameter Value Description
setid 8-character hexadecimal string,
for example, "010012D4" Sets the ID of the
transmitter without storing
it to EEPROM
setid_eeprom 8-character hexadecimal string,
for example, "010012D4"
Sets the ID of the
transmitter and stores it to
EEPROM
setclock String including Year, Month,
Day, Hours, minutes, and
seconds in the format
YYMMDDhhmmss Sets the transmitter clock
(only used for transmitters
without embedded GPS)