Vaisala Hydromet Data Collection Platform - Manual (Page 84)

User's Guide ______________________________________________________________________
82 __________________________________________________________________ M210933EN-C
0711-145 Figure 39 Measurements View: Communications for
Absolute Shaft Encoder
Setting Current Water Level for Absolute Shaft
Encoder
You can read or set the current water level, that is, the current data value
of the shaft encoder, using the following terminal command:
waterlevel [new value]
If you enter the parameter new value, the current data value is set as the
parameter value. If you do not enter the parameter, then the current data
value is displayed.
For example, read the current water level using the following command:
/> waterlevel
water level = 12.3400 m
To set the current water level, for example, to 5.480 meters, issue the
following command:
/> waterlevel 5.480
water level = 5.4800 m