Table 15, Available output variables, Lists the available output – Vaisala Hydromet Data Collection Platform User Manual

Page 160: Table 15 available output variables

Advertising
background image

User's Guide ______________________________________________________________________

158 _________________________________________________________________ M210933EN-C

Table 15

Available Output Variables

Variable

Data Type

Description

check_errs

Integer

Number of the failed downlink checksums

conn_GCC

Integer

Number of the connected ground stations (GCC)

inbound_message

String

Content of the latest inbound message

inbound_sender

String

Sender of the latest inbound message. If the sender is listed
in the speed dial list in the GCC, only the number is
available instead of the full internet address, for example,
OR08

inbound_subject

String

Subject of the latest inbound message

inbound_time

String

UTC time when the latest inbound message was received

lat

Float

Latitude from GPS

lon

Float

Longitude from GPS

msg_num

Integer

Number of the next message to be sent to the
communicator (SC). For example, when two messages
have been sent to communicator, the value is three

pass_msg_num

Integer

Number of the message that has been acknowledged by
gateway last, i.e., successfully transmitted. Value is
available after first transmission. Not applicable with
globalgrams.

pos_qual

Integer

Quality of the position information:

0 = GPS
1 = Good doppler ...
15= Poor doppler

qi_msgs

Integer

Number of inbound messages in SC

qo_msgs

Integer

Number of outbound messages in SC

sat_in_view

Integer

The ID number for the currently visible satellite. Zero if none
is visible.

sr_status

Integer

Status code from the last system response. The code is
available after first transmission. For details, refer to the
Orbcomm specification.

st_diag_code

Integer

Internal diagnostic code. For values, refer to the Orbcomm
SC specification.

status

Integer

General interface status:
0 = OK
1 = SC not accessed yet
2 = Reserved for future use
3 = Communication timeout
4 = Reserved for future use
5 = SC reports internal failure
6 = SC queue full

stored_sats

Integer

Number of the stored orbital elements. This indicates how
many different satellites the SC has acquired.

UTC

String

Current UTC date and time from GPS. Example: Thu Nov
01 11:35:16 2007

Advertising