Vaisala Hydromet Data Collection Platform - Manual (Page 223)

Chapter 5 __________________________________________ Configuring TCP/IP-Based Telemetry
VAISALA______________________________________________________________________ 221
To add a new host to the parameter set, proceed as follows:
1. In the Category window, select hosts, and click Add host. The
dialog shown in
Figure 96 on page 221 appears.
0906-027 Figure 96 Adding New Host to hosts
2. Enter hostname, select protocol, and select interfaces, if applicable.
Interface selection is needed only for HTPP proxy settings. Click
OK when done. Now the settings dialog looks as shown
Figure 97
on page 221 .
0906-028 Figure 97 Configuring Settings for a Host
3. Enter username, password, and service port, as required.