Xantrex Technology XDC 20-600 - Manual (Page 140)

Remote Operation
4–26 TM-XDOP-01XN
To recall last settings:
If you wish to recall the settings present when the supply was last powered off,
send the command:
SYST:REC:LAST
Change Remote/Local Control of Power Supply
A SCPI command is provided for use with the RS-232 and multichannel
interfaces to change the remote/local mode. (GPIB will use IEEE 4888-1
functions to change modes.)
SYST:REM:STAT {LOC|REM|RWL}
Where:
• LOC: go to local mode operation
• REM: go to remote mode operation
• RWL: remote with local lockout. Go to remote mode operation with local
mode locked out. With RWL set, the user cannot return to local mode via the
front panel.
To query to remote mode:
SYST:REM:STAT?
Enable Output
To enable or disable the output:
OUTP {ON|OFF}
To query the state of the output enable:
OUTP?
TM-XDOP-01XN.book Page 26 Monday, July 17, 2006 11:19 AM