Xantrex Technology XDC 20-600 - Manual (Page 84)

Operation
3–22 TM-XDOP-01XN
To create and save a user setting:
1. Set up the power supply with all the parameters you require.
2. Press .
3. Select a memory location, and press to save your settings.
The following table demonstrates how to set and save current and voltage
settings:
Change Stored Settings
To change a stored setting, overwrite it with a new setting, or select the setting,
press CE and hold it for a few seconds to clear the setting from memory.
STORE
ENTER
Step # Do This You Will See
1 Set #####V
2 Turn the Voltage knob or use the
numeric keypad to enter a voltage
setpoint. Set #####V
Your voltage setting appears on the
display.
3 Your voltage setting is saved.
4 Set #####A
5 Turn the Current knob or use the
numeric keypad to enter a current
setpoint. Your current setting appears on the
display.
6 Your current setting is saved.
7
Set 1 (unused)
a
a. (unused) appears with Set 1 if there are no saved settings in the system. Press Enter to save your
setting as Set 1. If (unused) does not appear, then you can overwrite Set 1 with your new setting or use
the numeric keypad or arrow keys to find the next unused set number. You can also press CE to clear
an existing setting and then press ENTER to replace the cleared setting with your new setting.
8 Set 1
Your voltage and current setting is
now saved as Set 1.
VOLTAGE
ENTER
CURRENT
ENTER
STORE
ENTER
TM-XDOP-01XN.book Page 22 Monday, July 17, 2006 11:19 AM