Xantrex Technology XDC 20-600 - Manual (Page 97)

Power Supply Operation
TM-XDOP-01XN 3–35
Setting step advance by time:
This procedure is continued from step 13 in the Table 3-2, “To Program a
Sequence” on page 3–33 table. It describes how to program the sequence to
advance a particular step by waiting for a certain time period.
The completion of this procedure will bring you back to step 15 of the Table 3-2
on page 3–33 table. Continue programming the current step.
Setting step advance by trigger:
This procedure continues from step 13 in the Table 3-2, “To Program a Sequence”
on page 3–33 table. It explains how to program the sequence to advance a
particular step by waiting for a certain trigger event. See “Editing Trigger Source
of a Sequence” on page 3–41 for more information about trigger event.
The completion of this procedure will bring you back to step 15 of the Table 3-2
on page 3–33 table. Continue programming the current step.
Step # Do This You Will See
Set Step Time
1
Enter the Step duration. The format of the
display is hh:mm:ss.ss.
Use the decimal key to move to the right.
T=##:##:##.##
2 To Next Step
ENTER
ENTER
Step # Do This You Will See
Set Step Time
1
or . Use the scroll keys to select
the Wait for Trig option.
Wait for Trig
2 To Next Step
 
ENTER
Important:
The default value for a sequence’s repeat time and trigger source is repeat once and
trigger from key. See “Editing Repeat Times of a Sequence” on page 3–40 and “Editing Trigger
Source of a Sequence” on page 3–41 for an explanation of how to edit these values.
TM-XDOP-01XN.book Page 35 Monday, July 17, 2006 11:19 AM