Xantrex Technology XDC 20-600 - Manual (Page 243)

S
C
PI C
o
mmand S
u
mmary
TM-XDOP-01XN
C
–19
Table C-9 System Commands
Function SCPI Command Description Query
Query System Error [:]SYSTem[<channel>]:ERRor[:NEXT]? Returns the next error in the
instrument’s error queue N/A
Recall Default
Factory Preset [:]SYSTem[<channel>]:RECall:DEFault Restore the factory preset values N/A
Select Remote
Control Source [:]SYSTem[<channel>]:REMote:SOURce
{RS232|GPIB|AVOLtage|ACURrent|AVCurrent|MCHann
el}
Select the remote control source Yes
Set RS-232 Baud
Rate [:]SYSTem[<channel>]:COMMunicate:SERial[:RECei
ve]:BAUD {1200|2400|4800|9600|…}
Configure the RS-232 baud rate Yes
Set RS-232 Flow
Control [:]SYSTem[<channel>]:COMMunicate:SERial[:RECei
ve]:PACE {HARDware|XON|NONE}
Select type of flow control for
RS-232 Yes
Set Multichannel
Address
(6000 W only) [:]SYSTem[<channel>]:COMMunicate:MCHannel:ADDR
ess <channel>
Select the multichannel unit
address Yes
Set GPIB Address [:]SYSTem[<channel>]:COMMunicate:GPIB[:SELF]:A
DDRess <GPIB_address>
Configure GPIB address Yes
Set GPIB Power On
Service Request [:]SYSTem[<channel>]:COMMunicate:GPIB[:SELF]:P
ONSrq {ON|OFF|0|1}
Configure GPIB PON SRQ Yes
Select Range for
Analog
Programming
Interface [:]SYSTem[<channel>]:COMMunicate:APRogram:LEVe
l {5|10}
Select analog interface voltage
levels Yes
Set Remote Control
Operation (Serial
Interface) [:]SYSTem[<channel>]:REMote:STATe
{LOCal|REMote|RWLock}
RS-232 Only. Change remote
control mode Yes
Query SCPI Version [:]SYSTem[<channel>]:VERSion? Returns the SCPI version to
which the instrument complies.
Format is YYYY.V N/A
TM-XDOP-01XN.book Page 19 Monday, July 17, 2006 11:19 AM