Xantrex Technology XDC 20-600 - Manual (Page 33)

Front Panel
TM-XDOP-01XN 1–7
Table 1-4 Front Panel Functions
Key Functions
Voltage Setpoint
Enter voltage
Current Setpoint Enter current
Output ON/OFF Toggle
Local/Remote Mode Toggle
Protection Set
OVP level
UVP level
OCP level
UCP level
OPP level
UPP level
Fold Mode Enter OV level
Enter UV level
Enter OC level
Enter UC level
Enter OP level
Enter UP level
Select fold mode
S/D if tripped?
S/D if tripped?
S/D if tripped?
S/D if tripped?
S/D if tripped?
Select fold delay Select Y or N
Select Y or N
Select Y or N
Select Y or N
Select Y or N
Read Alarms Read alarm msgs
Store User Setting Select 1 to 10
Recall Factory default
Last setting
User setting
Auto sequence
Select 1 to 10
Select 1 to 10
Auto Sequence Operation (Run/Pause, Trigger, Stop)
MENU
Access menu functions
ENTER Make a selection
UP/DOWN Scroll to view selections, increment numerical entries
CE Clear entry
Numeric keypad Enter data
EXIT Cancel operation
Special Key Functions
UP
View power readback (from default window)
CE Deletes a selected user setting from memory (Hold for 2 seconds)
EXIT Exit auto sequence
Menu Function
ERROR MSGS
Read error msgs
USER LINES Aux line A
Aux line B Configure aux line A
Configure aux line A Set aux line A polarity
Set aux line B polarity
PON CONFIG Factory default
Last setting
User setting
Auto sequence Set output on/off
Set output on/off
Select 1 to 10
Select 1 to 10
Set output on/off
Set output on/off
S/D RECOVERY Select OTP
recovery Select AC Off recovery
REMOTE
SELECT Select remote interface
TM-XDOP-01XN.book Page 7 Monday, July 17, 2006 11:19 AM