Leprecon LP-3000 Series - Manual (Page 103)

Moving Light Cue Playback Chapter Nine 99
LP-3000 Users Manual
To Convert a Cuelist to a Chase
1. Use the procedures described in Chapter Eight: Moving Light Cue
Programming to create a Moving Light cuelist.
2. From the Main screen, click ML Playback.
3. Scroll until the cuelist is visible on the screen.
4. Play back the cuelist by bringing up its playback fader.
5. Go to Run mode by pressing the Run button on the master panel.
6. Press and hold the Chase Enable button on the Master panel. While
holding the button, press the Select button above the playback.
The LP-3000 automatically converts the cuelist to a chase for playback. The
LP-3000 sequences through all programmed steps and then loops from the
last step back to the first.
7. To adjust the chase rate, hold down the playback Select button and tap the
Tap button located on the master panel above the Chase Level fader.
Faster tapping results in a faster chase. Slower tapping produces a slower
chase.
8. To save the chase rate, keep the chase running and put the LP-3000 in
Record mode.
9. Go to the Moving Light Programming screen and press the Add button of
the playback.
The rate set with the Tap button is a temporary change unless it is saved.
To Convert a Moving Light Chase back to a Cuelist
1. From the Main screen, click ML Playback.
2. Scroll until the chase is visible on the screen.
3. Go to Run mode by pressing the Run button on the master panel.
4. Play back the chase.
5. Press and hold the Chase Enable button on the Master panel. While
holding the button, press the Select button above the playback.
The LP-3000 automatically converts the chase back to a cuelist.
Converting a Moving Light Cuelist to a Stack Loop
Another unique feature of the LP-3000 will convert a Moving Light cuelist to a
Moving Light stack that will loop from the last step back to the first. This feature
provides a rolling cuelist that moves to the next step each time the Select button for
the playback is pressed.