Leprecon LP-3000 Series - Manual (Page 63)

Chases Chapter Five 59
LP-3000 Users Manual
The LP-3000 displays the Chase Builder screen.
2. Ensure that the LP-3000 is in Run mode.
If it is not, press the Run button on the Master panel of the LP-3000.
3. Move the preset scene playback fader from 0 to 1 on the fader scale.
4. Set the intensity of the chase by adjusting the Chase Level fader on the
Master panel of the LP-3000.
5. Move the preset scene playback fader to 0 to stop the chase.
To Set the Chase Rate
You can set the rate of a chase on a playback using the Tap button located on the
Master panel above the Chase Level fader.
1. With the chase running and the Chase Builder screen displayed, put the
LP-3000 in Run mode.
Press the Run button, located to the right of the key switch.
2. Press and hold the Select button of the playback.
3. Tap the Tap button to establish the chase rate.
The LP-3000 establishes the chase rate after just a few taps and then
averages any changes to the rate as you tap.
4. When you are done, release the Select button.
To Store the Chase Rate
1. With the chase running and the Chase Builder screen displayed, put the
LP-3000 in Record mode.
Press the Record button, located to the right of the key switch.
2. Press the Add button of the playback.
This stores the current chase rate in memory. The next time the playback is
used, the chase will return at the stored rate.
Run Controls
You can use the three display panel switches labeled Go, Hold and Back to control
chases.