Leprecon LP-3000 Series - Manual (Page 108)

104 Chapter Ten Advanced Moving Light Cue Programming
LP-3000 Users Manual
3. Select Multi-Part (No-Dowse).
This option enables you to program a cue in phases or “parts”. Unlike single
part cue programming, when you program in multi-part mode, all instruments
that are assigned to the cue stay lit, even if they are deselected.
4. Use the mouse to make your first instrument or group selection.
5. Use the edgewheels to select the labels for the selected instrument or
group.
See To Set Cue Properties by Label beginning on page 90 for complete
details.
6. Save the first cue part as you would normally.
7. Using the mouse, change the instrument selection.
8. Again, use the edgewheels to select the labels for the selected instrument or
group.
9. Click Save (at the right of the screen).
Because Multi-Part (No-Dowse) is selected, the LP-3000 adds these
instrument properties to the cue—instead of replacing or overwriting the cue.
10. Repeat steps 7 through 9 until you are done with the cue.
Be sure to deselect Multi-Part (No-Dowse) when you are done with your
multi-part programming.